dialog me palet e interesuara! Gjate periudhes Shkurt-Mars 2017 jane adoptuar 379 standarde shqiptare dhe dokumente shqiptare standardizimi, nga te cilat 313 Evropiane (CEN, CLC dhe ETSI) dhe 66 Nderkombetare (ISO dhe IEC) Per me teper >>



Çfarë mendoni se mund të përmirësohet nga DPS lidhur me shërbimet që ajo ofron?
Cilësia
Shpejtësia
Kompetenca
Bashkëpunimi
Informacioni
Votat në total: 152
 

SSH EN ISO 22477-10:2016

Statusi: Publikuar
Gjuha: Anglisht
Faqe: 28
Çmimi: 3748 lek
Standardet ndërkombëtare që lidhen
This standard is equivalent to:
EN ISO 22477-10:2016   CEN/TC 341
This standard is equivalent to:
ISO 22477-10:2016   ISO/TC 182


Printo


Titulli në shqip

Kërkim gjeoteknik dhe prova – Prova e strukturave gjeoteknike - Pjesa 10: Prova e shtyllave: prova e ngarkesës së shpejtë (ISO 22477-10: 2016)

Titulli në anglisht

Geotechnical investigation and testing - Testing of geotechnical structures - Part 10: Testing of piles: rapid load testing (ISO 22477-10:2016)

Qëllimi në shqip

Nuk është hedhur informacion.

Qëllimi në anglisht

ISO 22477-10:2016 establishes the specifications for the execution of rapid load pile tests in which a single pile is subject to an axial load in compression to measure its load-displacement behaviour under rapid loading and to allow an assessment of its measured compressive resistance (Rc,m) and corresponding load-displacement behaviour. ISO 22477-10:2016 is applicable to piles loaded axially in compression. All pile types mentioned in EN 1536, EN 12699 and EN 14199 are covered by this part of ISO 22477. The tests in this part of ISO 22477 are limited to rapid load pile tests only. NOTE 1 This part of ISO 22477 can be used in conjunction with EN 1997?1. Numerical values of partial factors for limit states from pile load tests to be taken into account in design are provided in EN 1997?1. For design to EN 1997?1, the results from rapid load pile testing will be considered equivalent to the measured compressive resistance, Rc,m, after being subject to appropriate analysis. NOTE 2 Guidance on analysis of the rapid load testing results to determine measured compressive resistance and corresponding load-displacement behaviour is given in Annex A. ISO 22477-10:2016 provides specifications for the following: a) investigation tests, whereby a sacrificial test pile is loaded up to ultimate limit state; b) control tests, whereby the pile is loaded up to a specified load in excess of the serviceability limit state. NOTE 3 Generally, an investigation test focuses on general knowledge of a pile type; a control test focuses on one specific application of a pile.

Komitetet Teknike


ICS



Direktivat

Nuk është hedhur informacion.

Veprim kombëtar

Nuk është hedhur informacion.